Warnings
•
Any work on electrical appliances must be carried out by qualified professionals.
•
Confirm that the power system is operational before working on the appliance.
•
Check that the appliance is restored to its original safety condition after the operation is complete.
•
Take the plug out of the socket to disconnect the power supply before you access internal componenets. This platform is
not fitted with an ON / OFF switch.
•
Warning sensors located on the display board could be at a potential of 220 Volts (If applicable).
•
Do not place any container under the appliance to avoid collecting drips of water.
•
Always empty the appliance before laying it on its side for any servicing.
•
The resistance values of the components shown in this Service Manual (SM) are purely indicative and approximate.
•
Replace the heating element with one that has the same characteristics to maintain safety
measures for the appliance.
•
Ensure gas pipelines are connected properly as mentioned in the installation section for gas
dryer models.
•
Lay down the machine on either side while servicing the unit. In such cases, some water in the detergent dispenser could
sip into the electrical / electronic components and cause these to burn.
•
Always place the cotton cloth below the machine to absorb water. There is a possibility of water leakage while servicing
the Drain Pump and Dispenser.
7
2. Warnings