CHAPTER 5 MECHANICAL CONSTRUCTION
4.
Removing the Stitcher Mount Unit
1) Remove the front inside cover. (See II-A-
3.)
2) Remove the E-ring [1] and take out the roll
[2] and the shaft [3].
3) Pull out the stitcher mount unit [4] to the
front.
5.
Adjusting the Stitcher Position
1) Remove the front lower door. (See II-A-1.)
2) Remove the front inside cover. (See II-A-
3.)
3) Open the front door assembly.
4) Pull out the stitcher mount unit to the front.
Then extract the stitcher towards you and
then pull the stitcher down.
5) Remove the three screws [1] and take out
the stitcher mount unit cover [2].
5-28
[2]
[1]
[3]
Figure 5-224
[4]
Figure 5-225
[1]
[2]
Figure 5-226