Removing The Upper Cover; Removing The Punch Motor; Puncher Driver System - Sharp AR-FN8 Service Manual

CHAPTER 5 MECHANICAL CONSTRUCTION
2.

Removing the Upper Cover

1) Remove the right guide assembly (See III-
A-1).
2) Open the front door [1], remove the three
screws [2], and take off the upper cover [3].
B.

Puncher Driver System

1.

Removing the Punch Motor

1) Remove the upper cover. (See III-A-2.)
2) Disconnect the connector [1].
3) Remove the two screws [2] and take out
the punch motor [3].
5-34
[3]
[2]
[1]
Front side
Figure 5-303
[1]
[3]
Figure 5-304
[3]
[2]
Rear side
[2]