Hitachi Hidic EH-150 Applications Manual page 21

Preliminary Rev.03
(2) Start up of the setup page
To display the initial window, please input the IP address of this module clearly with the area for URL input of
Web browser. For example, when the setting of the dip switch is table 5.5, please input
the URL input area of Web browser. This after the set up page will be displayed shown in figure 5.5.
1. Menu Frame
The Set up page is consisted by 3 kinds of frames shown in figure 5.5.
1. Menu frame
This frame is the menu to change the contents of the operation frame.
2. Operation frame
This frame is shown to configure the several parameters. This frame is consisted 2 kinds of frame.
Name
Display Frame
Configuration Frame
3. Error frame
If the illegal parameters on the operation frame are detected the error code will be displayed onto this error
frame. Please refer the detailed description in chapter 5.2.x.
The contents of this manual might be changed without notice.
Chapter 5 Configuration and procedure for starting communication
Table 5.5 The example of Setting the dip switch
Bit No.
1 2 3 4
OFF OFF OFF OFF
ON
Figure 5.5 Set up page
Table 5.6 Operation frame
This frame is used for displaying the current parameters related with the
selected link in the menu frame.
Display frame keeps the link(Setting) to the related configuration frame. To
change the current parameters please click this Setting link.
This is the frame to change the several parameters.
5-5
5 6 7 8
OFF OFF
ON
Description
http://192.168.0.4/ onto
2. Operation
Frame
3. Error
Frame