Hitachi Hidic EH-150 Applications Manual page 24

Preliminary Rev.03
Chapter 5 Configuration and procedure for starting communication
5.3.3 Configuration of connection for Task code communication
The setting procedure for Task code communication connection is described here.
(1) Displaying the "Task code display frame"
Select the "Task Code link selection" of menu frame then the operation frame changes to the "Task code
display frame". The current configuration is displayed onto the "Task code display frame". "Task code display
frame" is shown in figure 5.8.
Figure 5.8 Task code display frame
(2) Displaying the "Task code setting frame"
Select the "Setting link selection" of the Task code display frame then the operation frame changes to the
"Task code setting frame". "Task code setting frame" is shown in figure 5.9. And the parameters which can be
set by this setting frame are also shown in table 5.8.
Figure 5.9 Task code setting frame
5-8
The contents of this manual might be changed without notice.