Connect Interframe Signal Cables; Figure 22 Interframe Cables - GE Infinity M Series Installation Manual

NE-M Installation Guide

Connect Interframe Signal Cables

Step
`
P9
Connect 10 ft. RJ45 cable (847690799) into J2 on BIC 10.
1 Route to Millennium II Controller in Initial Frame.
Disconnect Factory RJ-45 cable from P9 and insert into Coupler.
Connect 10 ft. RJ45 cable (847690799) into J3 on BIC 10.
2
Route to Millennium II Controller in Initial Frame, insert in P9 connector of Millennium II Controller.
3 Connect 20 ft. 2-wire cable (850052873) bare ends to BIC 10 TB1: BL to SH-, W to SH+.
4 Route cable to Millennium II Controller P6.
5 Connect wires to butt splices on leade of P6 wire set – W to W-BL & BL to BL.
6 After applying power, configure Second battery shunt – see Configure Millennium II Controller section.
850050111 Issue 03 August 2017



Initial Frame
P6
Millennium II Controller

Figure 22 Interframe Cables

Connect RJ45 Cables
Connect Battery Shunt Cable
Action

Supplemental Frame
Battery Shunt Leads
to P6 Connector
BIC 10
Pin 10 - BL to Supp Frame BIC10 TB1-SH-
Pin 4 - W to Supp Frame BIC10 TB1-SH+
H5692448
 BIC 10
 Millennium II Controller
 Shunt RPM
BL W
Coupler
J3
J2
J1
Factory cable to
Rectifier Shelves
in Supplemental
Frame
24