Figure 77 Alarm Connections Millennium Ii - GE Infinity M Series Installation Manual

NE-M Installation Guide
Step
Connect and wire alarm and control signals to the BSL card as specified in site engineering instructions.
See Millennium II Alarm & Control Signals section for details.
3
NOTE: Wire Wrap
Punch Down Use 18 to 22AWG (if less than 18AWG, use multi-conductor cable for mechanical integrity).
Connect to network.
The controller provides an Ethernet connection for a LAN and or Craft port connection. Connector P2 provides a
standard RJ45 shielded receptacle connection for a standard Cat-5 connection to the controller's 10/100Base-T
4
port. This port has two main modes of operation: Server mode, LAN mode (Static and DCHP Client). In server
mode, the port can be used as a local Craft interface. In this mode, a local laptop can be connected through J5
and its standard web browser used to directly access the controller by typing in network address
http://192.168.2.1. A connection should never be made between the controller and LAN while the controller is in
Server mode.
Yes – go to Step 6.
Telephone Line Connection (Optional).
Door-mount MODEM option provide their own RJ11
5 connection for the telephone line.
Use appropriate routing techniques to connect the
controller respective RJ11 to the telephone line.
20
Punch down caps are furnished with the controller.
850050111 Issue 03 August 2017
Action – Millennium II
Alarm and Control Connections

Figure 77 Alarm Connections Millennium II

Use 24 to 30 AWG wire.
Strip approximately 1 inch of insulation from wire.
Use a standard wire wrap tool to connect each wire to its terminal.
Secure wires to terminals using a punch down tool or
Phillips #1 or #2 screwdriver inserted into a punch down insulating cap
Network (LAN) Connection (Optional)
Is the controller equipped with the Modem Option?
No – go to Step 7.
Modem is mounted on door near the controller.
H5692448
.
20
57