Install Controller; Install Pulsar Plus; Figure 68 Esd Grounding Connector; Figure 69 Alarm Relay Jumpers - Pulsar Plus - GE Infinity M Series Installation Manual

NE-M Installation Guide

Install Controller

Follow the procedures for the controller present in the system.

Install Pulsar Plus

Note: The controller is factory installed and connected to the NE-M equipment.
Connections to the controller made during installation are described here.
CAUTION: Equipment Damage
ESD NOTE: You must protect against ESD prior to configuring and installing the following circuit
cards.
Step
Configuring Individual Alarm Output Contact Type – "Close" on or "Open" on alarm
The factory default configuration for all alarm outputs is "Open On Alarm" on alarm.
Yes – go to Step 4.
Attach an ESD wrist strap or equivalent to the ESD
grounding connector on right hand side of the inside
of the frame.
1
Locate configuration jumpers for alarm relays on the controller.
Jumpers for each of the 10 output alarms are visible on the back of the door-mounted controller.
2
850050111 Issue 03 August 2017
Action – Pulsar Plus
Is this acceptable?
Alarm Relay Jumpers
Figure 69 Alarm Relay Jumpers – Pulsar Plus
No – go to Step 1.

Figure 68 ESD Grounding Connector

H5692448
ESD Grounding
Connector
48