Internal Ip Range Selection; Figure 3.1 Example Of A Lan Connection - Fujitsu ETERNUS LT260 User Manual

Chapter 3 Connections
3.1 Host Connection
■ LAN Connection
The LT260 requires a LAN connection for status monitoring, operation management, and maintenance of
various devices.

Figure 3.1 Example of a LAN connection

Administration terminal
(for remote panel)
(LAN port (MGMT: for remote panel))
■ LAN for operation management
By using a LAN, checking the LT260 status from the remote panel, sending the SMTP (e-mail sending) in the
event of a failure, and NTP (time correction) are available. In addition, functions that are provided by the
management/monitoring server on the LAN, such as SNMP (device monitoring) can be used.
3.1.2

Internal IP Range Selection

For internal communication between modules the tape library uses an Ethernet connection with an internal
IP address range. To prevent any conflict between the internal IP address range and the external IP addresses
it is required to select the internal IP range before the tape library gets connected to the external Ethernet
port.
The last section of the IP address is not set because it will be set internally.
FUJITSU Storage ETERNUS LT260 Tape Library User's Guide -Site Planning-
SNMP
Mail server
manager
LT260
33
Copyright 2018 FUJITSU LIMITED
NTP server
Remote support
center
P3AM-8782-06ENZ0