&DOLEUDWLRQ VFDOHV PDUNV ,5% ,' DQG ,5% ,'
The illustration below shows the location of the calibration scales on specific plates and the
calibration marks directly in the casting at axes 2 and 3.
xx0500002016
A
B
C
D
E
F
Calibration marks at axes 2 and 3
The calibration marks at axes 2, 3 and 6 shown in the figure above, consist of two single
marks that should be positioned opposite to one another when the robot is standing in its
calibration position. One of the marks is more narrow than the other and should be positioned
within the limits of the wider mark.
3HAC 16578-1 Revision: E
Calibration scale, axis 1
Calibration mark, axis 2
Calibration mark, axis 3
Calibration scale, axis 4
Calibration plate, axis 5
Calibration plate, axis 6
*HQHUDO LQIRUPDWLRQ
1.4. Calibration scales and correct axis position
&RQWLQXHG
&RQWLQXHV RQ QH[W SDJH
21