Table of Contents
Advertisement
2.2 Safety regulations for the method of operation
A6V11899867_en--_a
WARNING
Type and source of hazard
Consequences in the event the hazard occurs
●
Measures/prohibitions to prevent the hazard
DEPICTION for possible damage to property
Notes on possible damage to property is depicted as follows:
NOTICE
Type and source of hazard
Consequences in the event the hazard occurs
●
Measures/prohibitions to prevent the hazard
National standards, regulations and legislation
Siemens products are developed and produced in compliance with the relevant
European and international safety standards. Should additional national or local
safety standards or legislation concerning the planning, mounting, installation,
operation or disposal of the product apply at the place of operation, then these
must also be taken into account together with the safety regulations in the product
documentation.
Electrical installations
WARNING
Electrical voltage
Electric shock
●
Work on electrical installations may only be carried out by qualified
electricians or by instructed persons working under the guidance and
supervision of a qualified electrician, in accordance with the electrotechnical
regulations.
●
Wherever possible disconnect products from the power supply when carrying
out commissioning, maintenance or repair work on them.
●
Lock volt-free areas to prevent them being switched back on again by mistake.
●
Label the connection terminals with external voltage using a
'DANGER External voltage' sign.
●
Route mains connections to products separately and fuse them with their own,
clearly marked fuse.
●
Fit an easily accessible disconnecting device in accordance with EN 62368-1
outside the installation.
●
Produce earthing as stated in local safety regulations.
Safety regulations for the method of operation
Safety
2
19 | 122
Advertisement
Table of Contents
