Cigar Lighter; Using Cigar Lighter; Using Cigar Lighter Port As External Power Source - Hitachi ZW 120-6 Operator's Manual

Cigar Lighter

Using Cigar Lighter

d
WARNING: Never touch other than the knob part.
Otherwise, it may result in severe burns.
IMPORTANT: In case the cigar lighter does not pop out
automatically 30 seconds after pushing the cigar
lighter in, pull out the cigar lighter manually. Then,
consult your nearest authorized dealer.
1. Turn the key switch (1) ON.
2. Press and release the lighter knob (2).
3. The cigar lighter knob will return to the original position
when the lighter becomes usable. Pull the cigar lighter
out to use.
4. After using the cigar lighter, insert the cigar lighter into
the panel until the knob is seated in the original position.

Using Cigar Lighter Port as External Power Source

Use the cigar lighter port to supply power to lighting
equipment for servicing the machine.
IMPORTANT: 24 V DC electric power is available from
the cigar lighter port on this machine. The maximum
current is 5A (120W). Never connect accessories that
use power other than 24 V. Damage to the batteries
and accessories may result.
Do not supply power to accessories for a long time
without running the engine. Failure to do so may
discharge the batteries.
1. Pull the lighter knob out.
2. Correctly insert the accessory socket into the cigar
lighter port.
3. Turn key switch (1) ON. Power is supplied to the
connected accessory.
4. After using the accessory, disconnect the accessory
socket and insert the cigar lighter into the port.
OPERATOR'S STATION
1-66
2
1
1
MNDB-01-003
MNDB-01-053