Control Lever Lock Switch - Hitachi ZW 120-6 Operator's Manual

Control Lever Lock Switch

d
WARNING:
 Ensure that control lever lock indicator (2) on the
monitor panel is ON when control lever lock switch
(1) is in LOCK ( ) position, and indicator (2) is OFF
when control lever lock switch (1) is in UNLOCK
( ) position. In the case where indicator (2) does not
go ON or OFF, the control lever lock system may be
damaged. When the machine is operated with the
damaged control lever lock system, serious injury or
death may result. Consult your nearest authorized
dealer.
 Be sure to press LOCK ( ) side of control lever lock
switch (1).
 Before leaving the operator's seat, be sure to stop
the engine. Then, set control lever lock switch (1) to
the LOCK ( ) position.
 Always check to be sure that control lever lock switch
(1) is set in the LOCK ( ) position before transporting
the machine or leaving the machine at the end of the
shift.
Control lever lock switch (1) is provided to prevent the
machine unexpectedly operated even if the operator
mistakenly comes in contact with the bucket and/or lift arm
control lever when getting on or off the machine. When
control lever lock switch (1) is placed in UNLOCK ( ) position,
the control lever becomes operable.
Control Lever Lock Switch Operation
 When leaving the operator's seat:
1. Park the machine on solid level ground. Lower the
bucket to the ground. Return all levers to hold. Stop the
engine.
2. Press LOCK ( ) side of control lever lock switch (1).
Ensure that control lever lock indicator (2) on the
monitor panel is ON.
 Before starting operation:
Before starting operation, check that press UNLOCK ( )
side of control lever lock switch and control lever lock
switch (1) is in the UNLOCK ( ) position. Then, check that
control lever lock indicator (2) is OFF.
OPERATING MACHINE
5-2
1
MNCB-01-006
LOCK
UNLOCK
MNEC-01-015
2
MPTC-01-019