Table of Contents
Advertisement
Control Lever Lock Switch
d
WARNING:
Before leaving the operator's seat, be sure to stop
the engine. Set control lever lock switch (1) to the
LOCK ( ) position.
Always check to be sure that the control lever
lock switch is set in the LOCK ( ) position before
transporting the machine or leaving the machine at
the end of the shift.
Refer to section 5-4 for details.
Control lever lock switch (1) is provided to prevent the
machine from being mistakenly operated when the operator
accidentally touches the bucket and/or lift arm control lever
when getting on or off the machine. When control lever lock
switch (1) is placed to UNLOCK ( ) position, the front control
lever becomes operable.
Armrest Adjust Handle
The armrest is provided so that the operator can operate the
lever with an arm on the armrest, for comfort and ease.
Loosen handle (2) and position the armrest height to fit the
operator's preference, tighten handle (2) to fix the armrest.
L : Loosen
R : Tighten
Right Console Fore-aft Adjustment
Move arm rest (4) forward or backward by holding the arm rest
with your right hand while tilting lever (3) rightward (outside)
by holding the lever with your left hand. Stop the console at
an arbitrary position, and return lever (3) to original position
(inside) to secure the console.
Fore-Aft Position Adjustment : 90 mm
OPERATOR'S STATION
3
1-101
2
R
L
L
1
MNEC-01-526
1
LOCK
UNLOCK
MNEC-01-015
R
M4GB-01-077
4
MNEC-01-526
Advertisement
Table of Contents
