Table of Contents
Advertisement
Quick Power Switch
When quick power switch (4) is pressed while the power
mode switch is OFF, the work mode is temporarily switched
to P-mode. (The power mode indicator on the monitor is also
changed to
.)
f
NOTE: The quick power switch is operable only in the
following cases:
An added push to power mode power is needed during
digging (tractive) operation.
Need a little more acceleration or travel speed while
ascending on a slope.
When driving under low load or the forward/reverse lever is
in "Neutral" (N) position, the mode will not change to power
mode even if quick power mode switch is pressed. The switch
becomes invalid.
Also, even if the machine is in power-mode, it is canceled
when the following conditions are met.
When driving load is decreased while digging.
When the quick power switch is pressed.
The forward/reverse lever or forward/reverse switch is
shifted.
While driving in the auto-shift mode, the gear shifts up to
the selected gear stage.
OPERATOR'S STATION
1-104
4
4
MNEC-01-042
MNEC-01-043
Advertisement
Table of Contents
