Quick Power Switch - Hitachi ZW 370-6 Operator's Manual

Quick Power Switch

By pressing quick power switch (1) when the power mode is
OFF, the power mode is temporarily activated. (The power
mode indicator on the monitor shows symbol (
f
NOTE: The quick power switch is operable only in the
following cases.
 An added push is needed during digging (tractive)
operation.
 Need a little more acceleration or travel speed while
ascending on a slope.
When operating under low load or the forward/reverse lever
is in "Neutral" (N) position, the mode will not change to power
mode even if quick power mode switch is pressed. The switch
selection is ruled invalid.
Also, even if the machine is in the power mode, it is canceled
when the following conditions are met.
 When operating load is decreased while digging.
 When the quick power mode switch is pressed.
 The forward/reverse lever or forward/reverse switch is
shifted.
 While driving in the auto-shift mode, the gear shifts up to
the selected gear stage.
f
NOTE: The optional joystick steering lever has quick power
switch (1) as shown.
If the machine does not have the steering wheel, this switch
(1) works as upshift switch in Manual traveling mode only;
has no function in AUTO1 or AUTO2 mode.
OPERATOR'S STATION
).)
1-115
1
Fingertip Control Type
1
Multi-Function Joystick Type
1
MNEC-01-042
MNEC-01-043
95Z7-1-85-1