Digging And Loading Level Ground - Hitachi ZW 370-6 Operator's Manual

Digging and Loading Level Ground

IMPORTANT: While excavating with the bucket or fork,
never apply excessive force to the tooth tips with the
bucket or fork tilted more than 10°. This may result in
cracks or damage to the front attachment.
Slightly position the bucket teeth downward (0 to 10
degrees) and dig the ground while moving the machine
forward as described below. Always take care not to apply
loads to only to one side of the bucket.
1. Position the bucket teeth slightly downward (dump
forward 10 degrees or less).
2. While moving the machine forward in 1st or 2nd speed,
roll the bucket forward so that the ground surface is
gradually lifted.
Increase engine speed as the bucket digs deeper.
3. Adjust the digging depth by operating the lift arm or
bucket.
4. When the bucket is filled, move the machine with the
bucket fully rolled back. Clear the ground and hold at
the driving position.
OPERATING THE MACHINE
5-19
M4GB-05-007
M4GB-05-008
M4GB-05-009
M4GB-05-010