Tilt, Telescopic Lever/Steering Column Tilt Pedal; Wiper Switch; Wiper Operation - Hitachi ZW 370-6 Operator's Manual

Tilt, Telescopic Lever/Steering Column Tilt Pedal

d
WARNING:
 Before operating the machine, be sure that the
steering wheel is locked.
 Do not operate the tilt, telescopic lever (1) and
steering column tilt pedal (2) during operation.
d
CAUTION: Never attempt to drive the machine while
moving the steering column.
 Before operating the machine, adjust the steering
column inclination so as to match the operator's needs.
Pull lever (1) to set the steering column inclination to
the desired position. Push lever (1) until it contacts the
stopper, ensuring the steering column is locked.
 By depressing steering column tilt pedal (2), the steering
column moves forward, and the distance between
the operator's seat and the steering wheel increases,
allowing operator to get in and out of the machine
easily.
 After moving the steering column forward, pull the
steering wheel toward the operator. The steering column
will be automatically locked in the regular position and
the machine becomes operable.

Wiper Switch

Wiper Operation

IMPORTANT: The windshield surface, the wiper blade,
the wiper motor and the relay may be damaged due
to dry or frozen condition of the wiper blade and the
windshield.
 Before operating the windshield wiper, remove snow, ice
or dust heavy debris from the windshield surface. If the
windows are frozen over, defrost them.
 Use anti-freeze type washer fluid in freezing weather.
 Squirt windshield washer fluid on the dry windshield
before operating the wiper. Besides, continuous operation
of the wiper with windshield at semiarid condition
(sprinkling of snow or rain) may cause failure of the wiper.
Use wiper intermittently to protect it from damage.
 In case of machine equipped with hot-wire heater (for
windshield), continuous operation of the windshield wiper
with the heater switch kept ON for a long time may cause
the wiper blades to be burnt damaged by heat.
 Inspect the wiper blades weekly. Replace as necessary.
OPERATOR'S STATION
1-97
1 2
MNEC-01-037