Power Train; Check Transmission Oil Level - Hitachi ZW 370-6 Operator's Manual

Wheel loader
Table of Contents

Advertisement

C. Power Train

Check Transmission Oil Level

--- every 10 hours (daily)
d
WARNING:
 Move forward/reverse lever to neutral and turn
parking brake switch ON.
 After leveling the bucket on the ground, move the
control lever lock switch to the lock ( ) position.
 Set the articulation stopper (lock bar) (Refer to page
7-8).
IMPORTANT:
 Do not start the engine when the transmission oil
level is low. Damage to the transmission may result.
Do not use transmission oils other than those listed
in the "Transmission Oil".
 Never spray high pressure water to the cap and
vicinity of the cap. Water may enter into the
transmission, damage to the transmission may
result.
1. Park the machine on level ground, apply the parking
brake, and lower the attachment onto the ground.
2. Check the oil level with engine at low idle.
3. At low oil temperature, check if the oil surface level is
within the "COLD" window of sight gauge (2).
4. At high oil temperature, check if the oil surface level is
within the "HOT" window of sight gauge (2).
5. If the oil level is lower than the specified, add
recommended oil from filler port (1) while the engine is
at idle. Do not overfill.
MAINTENANCE
7-29
1
2
95Z7B-7-30-1
Transmission
oil temperature
gauge
95Z7B-1-23-1

Advertisement

Table of Contents

Troubleshooting

loading

Table of Contents