Table of Contents
Advertisement
Height/Lower Kickout ON/OFF, Stop Height Setting
Rotate selector knob (2) to highlight ON (8).
ON/OFF Selection
Press selector knob (2) to turn ON (enabled).
(A box next to ON turns green.)
This enables the setting of the lift arm height.
Press selector knob (2) again to turn OFF (disabled).
When the kickout is ON (enabled), indicator
be displayed on the monitor.
Display content
Segment (10) indicates current set value of the height or
lower kickout.
Segment (11) indicates current height of the lift arm.
Setting Operation
When the kickout is ON (enabled), the lift arm stop height
can be set.
When the lift arm height changes by operating the lift
arm control lever, the height is displayed on segment
(11).
When the lift arm height is within the setting range, the
mark
(9) will be displayed.
Rotate selector knob (2) to highlight
Press selector knob (2) to change the kickout setting
value.
When the kickout set value changes, the value displayed
on segment (10) will change accordingly.
OPERATOR'S STATION
(12) will
(9).
1-41
2
10
11
12
11
10
12
MNEC-01-006
8
9
MNHG-01-112EN
8
9
MNHG-01-113EN
Advertisement
Table of Contents
Troubleshooting
