Siemens SINAMICS S120 Manual page 15

3 DCC Blocks
Setting tip
Table 3-2
Group
MasterswitchMux
LimitSwitch
BrakeSlipDetection
TorqueProving1
TorqueProving2
CommonSignals
BrakeTest
BrakeFeedback
SpeedSetpoint
MicroSpeed
NOTE Do not calculate run-time group of all functions which are not necessary to the
ExtendedCraneDCC, and which are not used to optimize the computing time
utilization.
Extended Crane Drive-Based Technology AC
Extended Crane Drive-Based Technology SINAMICS S120
DCC Add-On Description 109767457,
Execution cycle in
case of STEP7
Receive after IF1
Profidrive PZD
Receive after IF1
Profidrive PZD
T = 1 * r21002
T = 1 * r21002
T = 1 * r21002
T = 1 * r21002
T = 1 * r21002
Receive after IF1
Profidrive PZD
Receive after IF1
Profidrive PZD
Receive after IF1
Profidrive PZD
V1.2, 09/2019
Execution cycle in
case of onboard
IOs
Read-in after digital Can be deactivated
inputs if function is not
required
Read-in after digital Can be deactivated
inputs if function is not
required
Can be deactivated
T = 1 * r21002
if function is not
required
Can be deactivated
T = 1 * r21002
if function is not
required
Can be deactivated
T = 1 * r21002
if function is not
required. Can not
run without
TorqueProving 1
T = 1 * r21002 Must always be
active
T = 1 * r21002 Can be deactivated
if function is not
required
Read-in after digital Must always be
inputs active
Read-in after digital Must always be
inputs active
Read-in after digital Can be deactivated
inputs if function is not
required
Remarks
15