Siemens SINAMICS S120 Manual page 44

3 DCC Blocks
SINAMICS
parameter
number
r22200 H1_boOut_NoLoadCondition
Detected
r22201 H1_boOut_TorqueProving
MonitoringFault
r22202 H1_rOut_ActualTorqueAtFault (%)
p22280 H2_boEnableStartPulse
p22281 H2_boEnableTorqueProving
p22282 H2_rSpeedController_I_
Component (r1482)
p22283 H2_rActualCurrent (r68.1)
p22284 H2_rMinimumTorque (%)
p22285 H2_rNoLoadTorque (%)
p22286 H2_boDeactivateTorque
ProvingAtNoLoad
p22287 H2_rMonitoringFaultDelay
Time (ms)
Extended Crane Drive-Based Technology AC
Extended Crane Drive-Based Technology SINAMICS S120
DCC Add-On Description 109767457,
Name Connection
V1.2, 09/2019
Default
type assignment
OUT 0
OUT 0
OUT 0
IN 0
IN 0
IN 0
IN 0
IN 0
IN 15
IN 0
IN 1000
Data Meaning
type
BOOL Verification from hoist
1 that a no load
condition as
parameterized in
p22165
(H1_rNoLoadTorque
(%)) has been
detected
BOOL If the actual torque
developed by hoist 1
does not meet r22197
(H1_rOut_Torque
ToBeProven (%)) in
the time period
specified in p22167, a
torque proving fault
(F51052) will be
triggered.
REAL Actual torque value
achieved by hoist 1
upon receiving torque
proving monitoring
fault.
Enables CraneDCC
BOOL
StartPulse for hoist 2
BOOL Enables torque
proving for hoist 2
REAL Connect r1482 (CO:
Speed controller I
torque output) from
hoist 2
REAL Connect r68.1 (CO:
Absolute current,
actual value,
Smoothed with
p0045) from hoist 2
REAL Desired minimum
torque value for
motor to reach before
brake is released for
hoist 2 (% of
maximum value)
REAL Actual torque at no
load for hoist 2
When a no load
BOOL
condition is detected,
torque proving is
disabled for hoist 2
Time in which if r80[1]
REAL
(CO: Torque actual
value, Smoothed with
p0045) is not greater
than r22317
(H2_rOut_TorqueTo
BeProven (%)), a
torque proving
44