Siemens SINAMICS S120 Manual page 18

3 DCC Blocks
SINAMICS Name
parameter
number
p21621
H2_boFeedback_
commandBrakeOpen
(r899.12)
p21622
H2_boFeedback_
commandBrakeClose
(r899.13)
p21623
H2_boFeedback_
DriveStationary (r1229.7)
p21624
H2_boFeedback_
Fault_Sinamics (r2139.3)
p21625
H2_boFeedback_AxisMoved
(r2199.1)
p21626
H2_boFeedback_Ramp
Complete (r2199.5)
p21627
H2_boFeedback_Nact>=0
(r2197.3)
p21628
H2_boExternalInterlockOff1
p21630
boFaultAcknowledge
r21631
H1_boOut_
ExternalFault (p2106)
r21632
H1_boOut_
ExternalAlarm (p2112)
r21633
H2_boOut_
ExternalFault (p2106)
Extended Crane Drive-Based Technology AC
Extended Crane Drive-Based Technology SINAMICS S120
DCC Add-On Description 109767457,
Connection
type assignment
IN
IN
IN
IN
IN
IN
IN
IN
IN
OUT
OUT
OUT
V1.2, 09/2019
Default Data type
0 BOOL
0 BOOL
0 BOOL
0 BOOL
0 BOOL
0 BOOL
0 BOOL
1 BOOL
0 BOOL
0 BOOL
0 BOOL
0 BOOL
Meaning
Connect hoist 2 r899.12
(Open holding brake)
Connect hoist 2 r899.13
(Command close holding
brake)
Connect hoist 2 r1229.7
(Brake threshold
undershot)
Connect hoist 2 r2139.3
(Fault present)
Connect hoist 2 r2199.1
(f or n comparison value
reached or exceeded)
Connect hoist 2 r2199.5
(Ramp-up/ramp-down
completed)
Connect hoist 2 r2197.3
(n_act >= 0)
Connect hoist 2 external
interlock signal here if
one exists, otherwise,
keep 1. When signal
changes states from 1 to
0, respone is OFF1 (i.e.
ramp down to zero
speed).
Connect signal for fault
acknowledgement
For hoist 1 in case of fault
this signal becomes low
in turn initiating external
fault (F07860) on
SINAMICS. R21631
should be connected to
p2106 of hoist 1
SINAMICS drive object
For hoist 1 in case of
alarm this signal
becomes low in turn
initiating external alarm
(A07850) on SINAMICS.
R21632 should be
connected to p2112 of
hoist 1 SINAMICS drive
object
For hoist 2 in case of fault
this signal becomes low
in turn initiating external
fault (F07860) on
SINAMICS. R21633
should be connected to
p2106 of hoist 2
SINAMICS drive object
18