Batch Setup Error Notification - Epson EV-110 User Manual

Copying Menu Settings Between Projectors (Batch Setup)
g Insert the SD card containing the saved batch setup file to the
projector's SD card slot.
h Hold down the [Menu] button on the remote control and connect the
power cord to the projector.
i When all of the projector's indicators other than the Wireless LAN
indicator turn on, release the [Menu] button.
When all of the indicators start flashing, the settings are being written.
When writing is finished, the projector turns off.
Caution
Do not disconnect the power cord or the SD card from the projector while
the file is being written. If the power cord or SD card is disconnected, the
projector may not start correctly.
j Remove the SD card.
g g Related Links
• "Batch Setup Error Notification"

Batch Setup Error Notification

The projector's indicators notify you if an error occurs during a batch setup
operation. Check the status of the projector's indicators and follow the
instructions described in the table here.
Indicator status Problem and solutions
The batch setup file may be corrupt, or the SD card may
• Laser: Orange - flashing
not be connected correctly.
fast
Disconnect the SD card, unplug and then plug in the
• Temp: Orange - flashing
projector's power cord, and then try again.
fast
p.141
Indicator status Problem and solutions
Writing the settings may have failed and an error may
• Power: Blue - flashing
have occurred in the projector's firmware.
fast
Stop using the projector, remove the power plug from
• Status: Blue - flashing
the electrical outlet. Contact Epson for help.
fast
• Laser: Orange - flashing
fast
• Temp: Orange - flashing
fast
g g Related Links
• "Projector Indicator Status" p.149
141