Adjusting Color Uniformity - Epson EV-110 User Manual

Using Multiple Projectors
• When you select [0] on the remote control, you can operate all
projectors regardless the Projector ID setting.
a
• When you set the Projector ID setting to Off, you can operate
the projector using the remote control whichever ID you select
on the remote control.
• The projector ID setting is saved in the remote control. Even if
the remote control batteries are removed to replace them, the
saved ID setting is retained. However, if the batteries are left
out of the remote control for an extended period, the ID
returns to its default setting (0).
• When you use multiple remote controls at the same time, you
may not be able to operate projectors as intended due to
infrared interference.

Adjusting Color Uniformity

If the color tone on the projected screen is uneven in each projector, adjust
the color tone balance using each projector's Extended menu.
• The color tone may not be uniform even after performing color
uniformity.
a
• When the Color Mode is set to Dynamic, this function is disabled.
s Image > Color Mode
a Press the [Menu] button, select the Extended menu, and press [Enter].
b Select Multi-Projection and press [Enter].
c Select Color Uniformity and press [Enter].
d Select Color Uniformity and press [Enter].
Select On and press [Enter]. Then press [Esc].
e
f Select Adjustment Level and press [Enter].
g Select the level and press [Esc].
There are eight adjustment levels from white through gray, and up to
black. You can adjust each level individually.
h Select Start Adjustments and press [Enter].
69