Running Light Source Calibration - Epson EV-110 User Manual

Running Light Source Calibration

Light source calibration automatically adjusts any difference between the
white balance and the brightness level of the light source. You should perform
light source calibration every 100 hours of projector usage. You can also
schedule automatic calibration or run the light source calibration manually
using the menus.
Automatic light source calibration may not start in the following conditions:
• Within 20 minutes of turning on the projector.
• When using direct shutdown.
• When you have used the projector continuously for over 24 hours.
• When the projector brightness is automatically dimmed due to high
temperatures.
a Press the [Menu] button, select the Reset menu, and press [Enter].
b Select Light Source Calibration and press [Enter].
c Select any of the following:
• To run the light source calibration now, select Run Now.
• To automatically run the light source calibration every 100 hours of
projector usage, select Run Periodically.
• To schedule automatic calibration, select Schedule Settings.
• To check the last time the projector performed a calibration, see Last
Run.
If you use the projector continuously for more than 24 hours or
use direct shutdown regularly, select Schedule Settings to
schedule calibration of the light source periodically.
a
d When you are finished, press [Menu] to exit the menus.
g g Related Links
• "Turning On the Projector" p.33
• "Turning Off the Projector" p.35
75