Wired Network Projection; Connecting To A Wired Network; Selecting Wired Network Settings - Epson EV-110 User Manual

Wired Network Projection

You can send images to your projector through a wired network. To do this,
connect the projector to your network, and then set up your projector and
computer for network projection.
After connecting and setting up the projector as described here, download
and install Epson iProjection (Windows/Mac) from the following Web site.
epson.sn
Epson iProjection software sets up your computer for network projection. See
the Epson iProjection Operation Guide (Windows/Mac) for instructions.
g g Related Links
• "Connecting to a Wired Network"
• "Selecting Wired Network Settings"

Connecting to a Wired Network

To connect the projector to a wired local area network (LAN), use a 100Base-
TX or 10Base-T network cable. To ensure proper data transmission, use a
Category 5 shielded cable or better.
a Connect one end of the network cable to your network hub, switch, or
router.
b Connect the other end of the cable to the projector's LAN port.
p.82
p.82

Selecting Wired Network Settings

Before you can project from computers on your network, you need to select
network settings on the projector.
Make sure you already connected the projector to your wired network
using the LAN port.
a
a Press the [Menu] button, select the Network menu, and press [Enter].
Select Network Configuration and press [Enter].
b
82