Mounting The Device On A Level Surface - Siemens SIRIUS 3TK2810-1 Manual

Assembling

5.2 Mounting the device on a level surface

5.2 Mounting the device on a level surface
Requirements
Please note the following requirements for mounting on a level surface:
• Please observe the information about the mounting position in Chapter "Technical data
(Page 71)".
• Two properly executed drill holes with thread or plug on the level surface
For details of the distances between the drilled holes, refer to the relevant dimension
drawings in Chapter "Dimension drawings (Page 73)".
• Two head screws with a maximum thread diameter of 5 mm
• Two plastic securing brackets
Please refer to the accessories list for the relevant order number in Chapter "Accessories
(Page 29)".
Procedure for mounting on a level surface
Step
38
Operating instruction
1 Insert the securing brackets into the openings pro‐
vided on the device until they engage.
2 Hold the device up to the surface prepared for screw
fastening.
3 Insert the screws through the oblong holes in the
securing brackets.
4 Screw the device onto the level surface so that it is
secure.
3TK2810-1 safety-related speed monitor
Equipment Manual, 05/2020, NEB926246402000/RS-AE/007
Figure