Table of Contents
Advertisement
Steps
1. Insert the power-button cable into the slot from the front-side of the computer, and press the power-button head until it
clicks into the place in the chassis.
2. Align and connect the power-button cable to the connector on the system board.
Next steps
1. Install the
hard-drive and optical-drive
2. Install the
3.5/2.5-inch hard-drive
3. Install the
side
cover.
4. Follow the procedure in
Optional I/O modules (HDMI/VGA/DP/Serial)
Removing optional I/O modules (HDMI/VGA/DP/Serial)
Prerequisites
1. Follow the procedure in
2. Remove the
side
cover.
3. Remove the
front
bezel.
4. Remove the
hard-drive and optical-drive
5. Remove the
heat-sink and fan
About this task
The following images indicate the location of the optional I/O Modules and provides a visual representation of the removal
procedure.
56
Removing and installing components
bracket.
assembly.
After working inside your
Before working inside your
bracket.
assembly.
computer.
computer.
Advertisement
Table of Contents
