Huawei AP2030DN Hardware Installation And Maintenance Manual page 50

Table of Contents

AP2030DN

Hardware Installation and Maintenance Guide

Procedure

Step 1 Hold the crimped connector, with the front side facing you, and check whether the contact

strips are of the same height. The height should be 6.02 ± 0.13 mm (0.237 ± 0.005). If a

measuring tool is not available, you can compare the connector with a standard connector.

Figure 5-32

Figure 5-32 Contact strips of different heights

Figure 5-33 Contact strips of the same height

Step 2 Hold an RJ45 connector and turn it 45°. Observe the top edges of the metal contact strips.

Figure 5-34

Issue 05 (2016-07-22)

To ensure conductivity, the surface of the contact strips must be clean.

The contact strips must be in good contact with the RJ45 socket. The plastic separators

must remain intact and be aligned.

The contact strip blade must extend beyond the ends of the wires. The ends of the wires

must be in contact with the edge of the RJ45. The distance between them must be less

than 0.5 mm (0.02 in.).

shows an unqualified piece, and

NOTE

All unqualified pieces must be crimped again.

shows an unqualified piece.

Huawei Proprietary and Confidential

Figure 5-33

shows a qualified piece.

5 Appendix

Table of Contents