Huawei AP2030DN Hardware Installation And Maintenance Manual page 59

AP2030DN
Hardware Installation and Maintenance Guide
l
----End
Installing the Cord End Terminal
Procedure
Step 1 Hold a cord end terminal upright and place it on a terminal jack, as shown in
ensure bump contact and dense connection, place the plain side of the terminal outwards.
Issue 05 (2016-07-22)
Figure 5-46 Bending the upper OT terminal at a 45- or 90-degree angle
Figure 5-47 Crossing two terminals
NOTICE
If the two terminals are different sizes, place the smaller one above the bigger one. A
maximum of two terminals can be installed on a post.
To remove an OT terminal, loosen the screw counterclockwise.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
5 Appendix
Figure 5-48. To
53