Assembling Sc-J2S(B) J4Kt15K, 22K - Mitsubishi Electric MELSERVO-J2S Series Manual

３.３.７ Assembling SC-J2S(B) J4KT15K, 22K
(１) Preparing to Assemble Renewal Kit (2)
Remove the attachment, which was mounted at the time
of shipment, to separate it into:
①the base, and
②the amplifier base.
(２) Mounting the Replacing Servo Amplifier on Renewal Kit
* You have no extra space between the servo
amplifier and Renewal Kit. To mount the
servo amplifier, use such a Phillips head
screwdriver as shown below.
Approx. 200mm
１．As shown in the drawing on the right, mount the replacing
servo amplifier on the amplifier base ② . To mount the
replacing servo amplifier, use the screws among the
accessories in the package (M5×12; 4 screws).
(３) Mounting Renewal Kit on the Control Panel
１. Use the currently used mounting opening and the
screws to mount the base ①.
２. Attach the amplifier base ② (with the replacing
servo amplifier mounted) on the base ①.
* To mount the amplifier base (with the replacing
servo amplifier mounted), insert the hook bolt
③ into the catch opening ④ (one opening) and
mount the amplifier safely.
* The servo amplifier is heavy.
Use caution when you mount it.
Note1
Pay attention to the direction of the base
① while mounting it. If you mount it
incorrectly, you will not be able to mount the
servo amplifier correctly. For the details,
see section 3.3.3, paragraph (8).
* If the currently used cables are too short,
you can mount the replacing servo amplifier
up to 30mm lower by inserting the hook bolt
into one of catch openings 1, 2, and 3.
②Amplifier base
Phillips head screwdriver
③Hook bolt
①Base
（Note 1）
②Amplifier base
(with the replacing servo
amplifier mounted)
３-３０
3 － 30
Replacing servo amplifier
①Base
Opening 3
Opening 2
Opening 1