Toshiba BU Series Instruction Manual page 24

- Line2 (I/O connector : 1 pin)
Input / Output specification
Factory setting
- Input signal specification
Level
Polarity
Pulse Width
Notes of external trigger signal:
Depending on cable length, cable kinds and input current of trigger input line, Random Trigger Shutter operation may not
satisfy timing specification or camera may not receive trigger signal. Please confirm it before use.
Notes of input level:
Line0 and Line2 have different input level. Please use input level within the voltage described in this specification.
- Output signal specification
Output Circuit
Maximum Current
Polarity
Signal Source (LineSource)
*Even if LineMode is set as Output, the input signal to Line2 is valid when LineSource is set as Off.
Input / Output circuit diagram
Copyright © 2016 – 2019 Toshiba Teli Corporation, All rights reserved.
: Input / Output (switch by LineMode is possible)
: Output
: Low 0 ~ 0.5V, High 4.0 ~ 5.0V
: High active / Low active (initial factory setting: Low active)
: Minimum 50μs
: 5V CMOS
: +/-32mA
: High active / Low active (initial factory setting: Low active)
: Off* / UserOutput / Timer0Active / AcquisitionActive
FrameTriggerWait / FrameActive / FrameTransferActive
ExposureActive
LineModeAll
Inside
DC5.0V
10kΩ
23 / 80
http://www.toshiba-teli.co.jp/en/index.htm
1
3
D4256843D
xB