Table of Contents
Advertisement
Installation Manual
Airbridge cBTS3612 CDMA Base Station
Unpack the box in the following
1)
Remove the metal strap of the box and open the cover of the box with a nail
hammer, pliers, flat-head screwdriver and crowbar.
2)
Insert the flat-head screwdriver into the gap of the top cover and loosen the
wood panel. Then use the crowbar to completely remove the panel.
3)
Take out the rack (do not remove the plastic bag before it is completely taken
out).
4)
Remove the plastic bag from the rack.
Unpack other cases in the same way described above.
There are wheels on the base of the BTS cabinet so it is convenient to move the
cabinet. When moving the cabinet between different floors, please hold the base or
other solid parts to avoid damage or accident.
II. Checking the cabinet
The appearance check is to ensure that there is no damage on the surface of the
rack. The front door and the back door are complete, the cover is well installed,
marks are clear and complete, the board name strip of the alarm box and the
decorating plate are complete, and there is no deformity in the cabinet. In addition,
the inside sanitation should be checked.
2.7.3 Unpacking Carton
Carton is generally used to pack various circuit boards and terminal equipment.
Circuit boards are transported in anti-static bags. When unpacking goods, anti-static
protective measures should be taken to avoid damage to the equipment. Pay
attention to the influence of the environment temperature and humidity. There is
drying agent in the anti-static bag to absorb the moisture in the bag.
Caution:
When the equipment is moved from a dry place with low temperature to a wet place with high
temperature, please wait at least 30 minutes before sealing off the equipment. Otherwise, it would result
in condensation of moisture on the surface of the equipment and damage the equipment.
steps:
2-10
Hardware Installation
2 Installation Preparations
Advertisement
Chapters
Table of Contents
