Figure 4-14 Cabling Diagram After 12-Core Fiber Fusing And Distributing Assemblies Are Installed - Huawei Airbridge BTS3606 Installation Manual

Installation Manual – BTS3606A Cabinet Installation
Airbridge BTS3606&3606A CDMA Base Station
To use the 12-core fiber fusing and distributing assemblies, proceed as follows:
1) Lead the optical fiber through the waterproof locknut at the cable inlet and then
into the enclosure.
2) On the optical fiber fixture, fix and strip the optical fiber, and then ground the core.
3) Take protective measures for the naked fiber coming out from the optical fiber
fixture, then coil it on the 12-core optical fiber fusing box, and fuse it with the tail
fiber.
4) Lead the tail fiber from the optical fiber fusing box to the cable distribution unit (that
is, 12-core optical fiber adapter installation support) to connect it with the adapter
of the cable distribution unit.
5) Lead the fiber jumper from the equipment through the fiber access saddle to the
fiber management tray and coil it.
6) Route the fiber jumper into the cable distribution unit to connect with the tail fiber,
as shown in Figure 4-14.
(1) Tail fiber
Figure 4-14 Cabling diagram after 12-core fiber fusing and distributing
assemblies are installed
Chapter 4 Installing Outdoor Transmission and
(2) Optical fiber
Huawei Technologies Proprietary
4-11
Power Interface Boxes
(3) Fiber jumper