Installation Manual – BTS3606A Cabinet Installation
Airbridge BTS3606&3606A CDMA Base Station
(1) Lug
Figure 3-1 Cabinet bearing points
3.1.2 Leveling Cabinet
To level the cabinet, proceed as follows:
1)
Use a level bar to check the levelness of the cabinet in both the latitudinal and
longitudinal directions.
2)
Observe whether the level vial is in the middle of the level bar.
3)
Adjust the levelness by adding washers between the cabinet and base, as shown
in Figure 3-2 and Figure 3-3.
(2) Mount angle
If there is no error, fasten the cabinet by following the instructions in section
3.1.3 "Fastening Cabinet".
If an error exists, lift the cabinet.
Huawei Technologies Proprietary
Chapter 3 Installing Cabinet and Cabinet Equipment
3-2