Cabling Diagram - Huawei Airbridge BTS3606 Installation Manual

Installation Manual – BTS3606A Cabinet Installation
Airbridge BTS3606&3606A CDMA Base Station
I. Cable Inlet
Cable inlet is the entrance where the cables are led into the cabinet.
All external cables of the BTS3606A are led into the cabinet from the inlets on the front
part at the bottom of the cabinet.
II. Cable Distribution Region
Cable distribution region refers to the area where external cables connect to the
BTS3606A cabinet.
The BTS3606A cabinet allows front maintenance. Except that RF cables and
GPS/GLONASS synchronous clock jumpers, all cables are led in from the inlets on the
front part at the bottom of the cabinet.

5.2 Cabling Diagram

Caution:
Ensure that the power supply is off before installing cables. Hot-line operation is
prohibited.
The installation sequence of cables depends on the onsite situation.
Figure 5-1 shows the front cabling diagram of the BTS3606A cabinet and Figure 5-2
the rear cabling diagram of the BTS3606A cabinet. These two diagrams describe
reference positions of all cables.
Huawei Technologies Proprietary
5-4
Chapter 5 Installing Cables