Installation Of Cabinet; Positioning Cabinet - Huawei Airbridge BTS3606 Installation Manual

Installation Manual – BTS3606A Cabinet Installation
Airbridge BTS3606&3606A CDMA Base Station
Chapter 3 Installing Cabinet and Cabinet
This chapter introduces how to install the BTS3606A cabinet, the battery cabinet, and
the equipment inside these cabinets.

3.1 Installation of Cabinet

During the installation of combined cabinets, the extension cabinet is installed in the
same way as the basic cabinet.
To install the basic cabinet, proceed as follows:
1) Position the cabinet.
2) Level the cabinet.
3) Fasten the cabinet.
4) Install accessories.

3.1.1 Positioning Cabinet

Lift and place slowly the cabinet over the base and align the installation holes on the
bottom of the cabinet with those on the base.
Caution:
An empty cabinet weighs 450 kg (992 lb.). Confirm the lifting capability of the lifting
equipment beforehand.
When lifting the cabinet, make sure that all the four lugs are reliably hooked, the
angle between the lifting rope and the top of the cabinet is at least 60
cabinet is level. Installers must stay away from the cabinet when lifting it and make
sure that the front and rear doors are closed.
When installing the cabinet in bad conditions (for example, when there is strong
wind), pay extra attention to the gravity center of the cabinet to prevent the cabinet
from slanting.
If the cabinet cannot be lifted on site, position the cabinet according to the bearing
points shown in Figure 3-1 and site characteristics.
Chapter 3 Installing Cabinet and Cabinet Equipment
Equipment
Huawei Technologies Proprietary
3-1
o
, and the