Installing Input Components Of Single-Phase Mains And Diesel; Figure 4-18 Installing Grounding Cable For Enclosure - Huawei Airbridge BTS3606 Installation Manual

Installation Manual – BTS3606A Cabinet Installation
Airbridge BTS3606&3606A CDMA Base Station
(1) Grounding nut

Figure 4-18 Installing grounding cable for enclosure

4.4.3 Installing Input Components of Single-phase Mains and Diesel

Caution:
Make sure that the connection of neutral line (N) and live line (L) are correct. If they are
inversely connected, accidents may result.
To install input components of single-phase mains and diesel, proceed as follows:
1) Unpack the power interface box and the air breaker assemblies of the diesel.
2) Check that enclosure, mains air breaker, diesel air breaker, air breaker interlock
device, and input/output terminal block are all available.
3) Mount the diesel air breaker assemblies onto the enclosure by following the
instruction in section 4.4 "Installing Outdoor Power Input Components".
4) Connect the load live line to terminal A, B, or C, and the neutral line to terminal N,
as shown in Figure 4-19.
Chapter 4 Installing Outdoor Transmission and
Huawei Technologies Proprietary
4-14
Power Interface Boxes