NEC DS1000 Quick Setup Manual page 28
Hide thumbs
Also See for DS1000:
- Feature handbook (216 pages) ,
- Correspondence course workbook (174 pages) ,
- Product description (174 pages)
Table of Contents
Advertisement
Section 2: Customizing Features
Part II: Enable/disable Caller ID Class of Service options:
- Caller ID display (enabled by default).
- Second Call Caller ID (enabled by default).
- Third Party Caller ID Check (disabled by default).
- Caller ID display separator (disabled by default).
Part III: Assign the Class of Service with the Caller ID options set to the extension.
Part IV: To enable Caller ID Logging, assign the Caller ID Outbound Line/Group and the system's
Home Area Code (HNPA). (To set up additional Caller ID Logging options, refer to the Caller ID Log-
ging feature in the Software Manual on the System Document CD that came with your system.)
Part I: Enable/Disable Caller ID Trunk Options:
1.
Enter the programming mode. You see:
USER: nnn
ENTER PROGRAM?
2.
Enter 1001 + HOLD . You see:
1001:TRK DESCRIPTIOM
TRUNK PORT?n
3.
Enter the trunk you want to program (e.g., 1) + HOLD . You see:
1001:TRUNK PORT:n
TYPE?nnnn nnnn nnn
4.
Press Vol Up until you see:
1001:TRUNK PORT:n
CALLER ID?nnn
5.
To enable Caller ID for the trunk in DS2000 software version 02.02.14 or higher with P/N 80011B
ATRU PCBs or DS1000, dial 1 (for DSP) + Vol Up .
To enable Caller ID for the trunk in DS2000 software versions prior to 02.02.14 and all versions with-
out P/N 80011B ATRU PCBs, dial 2 (for daughter board) + Vol Up .
To disable Caller ID for the trunk, dial 0 + Vol Up . You see:
1001:TRUNK PORT:n
VOICE MAIL CLID?nnn
6.
To enable Caller ID integration with Voice Mail, dial 9 (for yes) + HOLD .
To disable Caller ID integration with Voice Mail, dial 6 (for no) + HOLD .
7.
Press CONF to go back to step 3 and select another trunk.
Press CONF twice to exit program 1001.
Part II: Enable/Disable Caller ID Class of Service Options:
1.
Enter the programming mode. You see:
USER: nnn
ENTER PROGRAM?
2.
Enter 0101 + HOLD . You see:
0101:CLASS OF SERVICE
COS NUM?n
3.
Enter the Class of Service (1-15) you want to program + HOLD . You see:
0101:COS:n
OFF PREM FWRD?nn
4.
Press Vol Up until you see:
0101:COS:n
CLID DISPLAY?nnn
5.
To enable Caller ID for the Class of Service, dial 9 (for yes) + Vol Up .
2-6
Section 2: Customizing Features
OR
OR
OR
OR
By default, the attendant (extension 300) has Class of Service 1. All other extensions have Class
of Service 2.
DS1000/2000 Quick Setup Guide
Advertisement
Table of Contents
