Using Program 9902 In Ds2000 To Add Or Delete Pcbs - NEC DS1000 Quick Setup Manual

Using Program 9902 in DS2000 to Add or Delete PCBs

Use 9902 - Slot Assignment to enable any PCBs you have plugged into slots CN2-CN8. If you don't enable
the PCBs plugged into slots CN2-CN8 in this program, they will not function. (Note that by default, slot
CN1 is assigned as a 16DSTU PCB for extensions 300-315.)
•
•
To add or delete a PCB:
1. Enter the programming mode.
2. Enter
Start
Vol Up to select
slot (2-8).
Program another PCB
Program another PCB
Vol Up to select
slot (2-8) to delete.
Start
You should see the
previous slot assignment
DS1000/2000 Quick Setup Guide
You can only enable a PCB if its slot is empty (unassigned) in programming.
To delete a PCB in slots CN2-CN8 (so you can enable it with a new assignment),
see Deleting PCBs in 9902 - Slot Assignment below.
9902 + HOLD and follow the charts below.
Enabling PCBs in 9902 - Slot Assignment
HOLD HOLD
You should see:
EMPTY SLOT
You should see:
ADD CARD (Y/N)?
OR
You should see:
SLOT NUMBER?
Exit
CONF
OR
Deleting PCBs in 9902 - Slot Assignment
HOLD HOLD
You should see:
REMOVE CARD (Y/N)?
Section 1: Start-up Programming
Enabling PCBs
Vol Up
Y (9) + ICM
card type.
ICM flashes
You should see:
FIRST EXTENSION?
HOLD HOLD
You should see:
SLOT CONFIG CHANGED
Y (9) N (6)
You should see:
ABORT (Y/N)?
You should see: SLOT
CONFIG CHANGED!
Section 1: Start-up Programming
to select
HOLD
Enter the PCB's
first extension.
OR
HOLD
Exit
CONF
1
1-5