Adjusting The Shift Pedal - Yamaha FJR1300N 2001 Service Manual

BLEEDING THE HYDRAULIC BRAKE SYSTEM/

ADJUSTING THE SHIFT PEDAL

g. Loosen the bleed screw.
NOTE:
@
Loosening the bleed screw will release the
pressure and cause the brake lever to contact
the throttle grip or the brake pedal to fully
extend.
h. Tighten the bleed screw and then release
i. Repeat steps (e) to (h) until all of the air
j. Tighten the bleed screw to specification.
k. Fill the brake fluid reservoir to the proper
@
After bleeding the hydraulic brake system,
check the brake operation.
EAS00136
ADJUSTING THE SHIFT PEDAL
1. Check:
2. Adjust:
a. Loosen both locknuts 2.
b. Turn the shift rod 3 in direction a or b to
3 - 61
the brake lever or brake pedal.
bubbles have disappeared from the brake
fluid in the plastic hose.
Bleed screw
6 Nm (0.6 m · kg)
level with the recommended brake fluid.
Refer to "CHECKING THE BRAKE FLUID
LEVEL".
WARNING
• shift pedal position
The end 1 of the shift pedal with the left
middle gear cover bolt.
Incorrect → Adjust.
• shift pedal position
obtain the correct shift pedal position.
Direction a
Shift pedal is raised.
Direction b
Shift pedal is lowered.
CHK
ADJ