CYLINDER HEAD
d. Place a 400 ~ 600 grit wet sandpaper on
the surface plate and resurface the cylinder
head using a figure-eight sanding pattern.
NOTE:
@
To ensure an even surface, rotate the cylinder
head several times.
EAS00232
INSTALLING THE CYLINDER HEAD
1. Install:
• dowel pins 1
• gasket 2
2. Install:
• cylinder head
NOTE:
@
Pass the timing chain through the timing chain
cavity.
3. Tighten:
• cylinder head bolts (M10) 1
NOTE:
• Do not reuse the cylinder head bolts.
• The tightening procedure of the cylinder
head bolts is angle controlled, therefore
tighten the bolts using the following proce-
dure.
a. Lubricate the cylinder head bolts and wash-
ers with engine oil.
b. Install the washers and cylinder head bolts.
c. Tighten the cylinder head bolts in the proper
tightening sequence as shown.
Cylinder head bolt (M10)
1st
25 Nm (2.5 m · kg)
5 - 21
ENG
New
New