Checking The Friction Plates - Yamaha FJR1300N 2001 Service Manual

CLUTCH
6. Remove:
• spacer 1
NOTE:
@
• Insert a cross-headed screwdriver into one of
the holes of the clutch housing and primary
driven gear, and then rotate the inner pri-
mary driven gear until both primary driver
gears are aligned. The teeth of both primary
driven gears must be aligned for installation.
• Insert two 5-mm bolts 2 into the spacer and
then remove the spacer by pulling on the
bolts.
EAS00280

CHECKING THE FRICTION PLATES

The following procedure applies to all of the
friction plates.
1. Check:
• friction plate
Damage/wear → Replace the friction plates
as a set.
2. Measure:
• friction plate thickness
Out of specification → Replace the friction
plates as a set.
NOTE:
@
Measure the friction plate at four places.
Friction plate thickness
2.9 ~ 3.1 mm
<Limit>: 2.8 mm
5 - 49
ENG