Installing The Rear Balancer - Yamaha FJR1300N 2001 Service Manual

BALANCERS
7. Start the engine and check that there is no
abnormal noise coming from the balancer
gear. If noise is abnormal, adjust the gear
lash by turning the balancer shaft.
NOTE:
With each adjustment, turn the balancer shaft
one scale.
Clockwise
Counterclockwise

INSTALLING THE REAR BALANCER

1. Install:
• balancer weight 1
• absorbers
• balancer gear 2
• bearings
• washers
NOTE:
Align the punch mark a in the balancer weight
with the mark b in the balancer gear.
2. Align:
• "T" mark on the pickup coil rotor
(with the crankcase mating surface)
a. Turn the crankshaft clockwise.
b. When piston #1 is at TDC on the compres-
sion stroke, align the "T" mark a on the
pickup coil rotor with the crankcase mating
surface b.
NOTE:
@
TDC on the compression stroke can be found
when the camshaft lobes are turned away from
each other.
5 - 123
ENG
Decrease gear lash
Increase gear lash