ADJUSTING THE SHIFT PEDAL/CHECKING THE FINAL
DRIVE OIL LEVEL/CHANGING THE FINAL DRIVE OIL
NOTE:
Make sure that the mark on the shift pedal is
between the marks on the frame.
c. Tighten both locknuts.
EAS00144
CHECKING THE FINAL DRIVE OIL LEVEL
1. Stand the motorcycle on a level surface.
NOTE:
@
• Place the motorcycle on a suitable stand.
• Make sure the motorcycle is upright.
2. Remove:
• final drive housing oil filler bolt 1
3. Check:
• final drive oil level
The final drive oil level should be to the bot-
tom brim 1 of the filler hole.
Below the bottom brim → Add the recom-
mended final drive oil to the proper level.
Recommended oil
Drive shaft gear oil
4. Install:
• final drive housing oil filler bolt
EAS00145
CHANGING THE FINAL DRIVE OIL
1. Place a container under the final drive
housing.
2. Remove:
• final drive housing oil filler bolt 1
• final drive housing oil drain bolt 2
Completely drain the final drive housing of
its oil.
3 - 62
CHK
ADJ
23 Nm (2.3 m · kg)