Connecting Pc To The Fl654; Starting Ms Windows Hyperterminal - Toshiba V Series User Manual

Chapter 6 I/O Module Registration and Setting Method

6.2 Connecting PC to the FL654

Connect a PC to the FL654 using the cable between the PC's RS-232C port and the
FL654's TOOL connection port. (For the connection cable, see Chapter 3.)

6.3 Starting MS Windows HyperTerminal

Start the MS Windows HyperTerminal, register the name, and set up the property as
follows:
6
Transmission rate
Data bit
Parity
Stop bit
Flow control
Line-feed code for talk
Line-feed code for listen
Local echo
A specific HyperTerminal setup screen is shown in Figure 6-1.
22
Table 6-1 HyperTerminal Property
Item
19200bps
8 bits
None
1 bits
None
CR
CR
ON
Figure 6-1 Specific HyperTerminal Setup Screen
Model 2000 FL-net (OPCN-2) Remote I/O Station Module (FL654) User's Manual
Settings Remarks