Startup Procedure Flow - Toshiba V Series User Manual

Chapter 5 Startup

5.1 Startup Procedure Flow

(1) For performing I/O module input/output based on saved information:
5
Figure 5-1 FL654 Startup Procedure if I/O Module Input/Output is Performed Using Saved
(2) For performing I/O module input/output in the current I/O module configuration
18
Begin
(i) Install the power, expansion, FL654, and I/O
modules in the base unit. When the expansion unit
is used, connect an expansion cable.
(ii) Turn ON the power (the FL654 automatically
recognizes the connected I/O modules).
(iii) Connect a PC to the TOOL connection port
and check I/O module
HyperTerminal.
(iv) After checking I/O module connections, once
turn OFF the power and return the FL654 switch
settings to ordinary usage condition.
(v) Connect the communication cable.
(vi) Turn ON the power.
Start up
Begin
(i) Install the power, expansion, FL654,
and I/O modules in the base unit. When
the expansion unit is used, connect an
expansion cable.
(ii) Connect the communication cable.
(iii) Turn ON the power.
Start up
Figure 5-2 FL654 Startup Procedure if I/O Module Input/Output is Performed in the
FL654 switch settings in step (i)
・Node address: Depends on the system.
・Talker block head and listener block head:
Depends on the system.
・RUN/HALT switch: HALT
・Operation setting switch:
Ethernet setting:
I/O composition setting: CONF
I/O status setting in down mode:
connections using
For more information on check in step (iii),
see Chapter 6.
FL654 settings in step (iv) (settings to be
changed)
・RUN/HALT switch: RUN
・Operation setting switch:
I/O composition setting: LOCK
After
automatically performed based on the saved
I/O information when power is turned ON in
this condition.
I/O Information
FL654 switch settings in step (i)
・Node address: Depends on the system.
・ Talker block head and listener block
head: Depends on the system.
・RUN/HALT switch: HALT
・Operation setting switch:
Ethernet setting:
I/O composition setting:
I/O status setting in down mode:
Current I/O Module Configuration
Model 2000 FL-net (OPCN-2) Remote I/O Station Module (FL654) User's Manual
Set according to the system.
Generally, auto-negotiation is set.
Depends on the system.
that, I/O module input/output
Set according to the system.
Generally, auto-negotiation is set.
I/O module input/output based on
the current I/O module configura-
tion
Depends on the system.
is