Positioner Without Function - ABB TZIDC Manual

TZIDC, TZIDC-200 DIGITAL POSITIONER | COI/TZIDC/TZIDC-200-EN REV. B

Positioner without function

Connect 4 to 20 mA.
Is the display active?

Yes
Connect compressed air.
Now is it working?

No
Switch the positioner to operating mode
1.2 (manual). Press the arrow button
briefly.
Press the second arrow.
Now is it working?

No
Check the safety position of the
pneumatic output module and compare
IP-Typ
with the parameter. The safe
position must be activated (FAIL_POS)
before the parameter can be changed.
Save parameters.
Now is it working?

No
Return the defective positioner for
repair.

Swap the connection wires + and −. Now
No is the display active?

No
Check the power source or return
defective positioners for repair.

Good job!
The work activities are completed.
Yes
Start Autoadjust. Save parameters and
switch the positioner to operating mode

1.1. In case of error messages, check the
Yes
mechanical configuration.
Now is it working?

No
Press the  button to read the current
value.
Is the current value correct?
Good job!

Work activities are
over after starting
Yes
Autoadjust!

Yes

Yes

No

Yes
Switch the
function for the
digital input
(FUNCTION) to
none.
Good job!
The work activities are completed.
Good job!
The work activities are completed.
Check power source or PLS.
45