Panasonic WJ-SX 150A Operating Instructions Manual page 113

Moving the Camera Title Display
Move the joystick while holding down the OSD, SHIFT and
2 buttons. (2) will move to the desired direction.
Moving the Event Display
Move the joystick while holding down the OSD, SHIFT and
3 buttons. (3) will move to the desired direction.
Moving the Monitor Status*
Move the joystick while holding down the OSD, SHIFT and
4 buttons. (4) will move to the desired direction.
* Monitor number, controller number and monitor mode
Moving All the Items
Move the joystick while holding down the OSD, SHIFT and
5 buttons. (1), (2), (3), and (4) will move to the desired
direction.
System Status Table
The table shows the current system status.
1. Select the desired monitor. (Refer to p. 106 Monitor
Selection.)
2. Press the button 9 while holding down the OSD button.
"OSD" will appear on the LED display, and the SYSTEM
STATUS table will appear on the active monitor as
shown in the figure.
MON CAM
1 01
2 99
3 04
4 R1
F1 ACK
CAM SETUP SUSPEND
F2 GROUP SEQ
INDEX
PREV
RECORDER
STOP
STOP PLAY
OSD
SETUP
116
SYSTEM STATUS
MODE KB OPE
T01 K1 12345
SPOT K2 2
ALARM K4 4
RECORDER PC 30
RESET
ALL RESET
TOUR SEQ
T&D CAM ID EVENT
REW/FF AUX1 OFF AUX1 ON
STILL
NEXT
MON STATUS ALL
AUX2 OFF AUX2 ON
STEP EL-ZOOM
PAUSE
ALM H VLD H SYS S
DEF OFF DEF ON
PAUSE SEQUENCE
MON (ESC) CAM (SET)
MON LOCK WIPER
SHIFT MULTI SCREEN SEL
The columns in the table indicate the states as shown in the
figure.
MON:
CAM:
MODE:
KB:
OPE:
PRI:
* R0 to R4 shows the following.
Recorder number
** When this parameter is selected, a recorder number is
displayed in the CAM area.
3. To exit from the mode, press the CLEAR button.
PRI
30
2
1
1
CALL
PRESET
PROGRAM
PRESET
AUTO PAN
CAM FUNC
CLEAR
LOG OUT
Monitor number
Logical camera number (01 to 99)
Recorder number (R0 to R4)*
No number indicates no camera is
selected.
Lists the display mode on the
monitors.
SPOT: Spot mode
Tnn: Tour Sequence mode (nn is the
tour sequence number.)
CAM: Camera Setup mode
SET: WJ-SX150A Setup mode
ALARM: Alarm Active mode
ACK: Alarm ACK mode
VLD H: Video Loss History Table
ALM H: Alarm History Table
SYS S: System Status Table
RECORDER: Recorder mode**
Lists the system controller name
(K1 to K4) or PSD.
Lists the operator number
Lists the priority number
Recorder
R0 Master recorder
R1 Slave 1 recorder
R2 Slave 2 recorder
R3 Slave 3 recorder
R4 Slave 4 recorder